Product Data Sheet Safety Data Sheet Show all documents
SikaPlast®-178 KH

SikaPlast®-178 KH

PCE BASED SUPERPLASTICIZING AND SET RETARDING CONCRETE ADMIXTURE

SikaPlast®-178 KH is a 3rd generation polymer based high performance superplasticizer for producing soft con- sistency concrete.

  • Long slump keeping and high water reduction
  • High flowability (considerably reduced placing and compacting work)
  • Faster evolution of early strength development
Where to Buy
Product Data Sheet Safety Data Sheet Show all documents

Usage

SikaPlast®-178 KH mainly suitable for the manufacture of concrete for RMC plants and site batch concrete. SikaPlast®-178 KH is used for the following types of concrete:
  • Bored piles
  • Barrette foundations and diaphragm walls
  • Ground and suspended slabs
  • Columns and walls
 

Advantages

SikaPlast®-178 KH combines different modes of actions. By adsorption on the surface of the fines and keeping them apart while the hydration is in progress, SikaPlast®-178 KH effects the following concrete properties:
  • Long slump keeping and high water reduction
  • High flowability (considerably reduced placing and compacting work)
  • Faster evolution of early strength development
  • Workability can be maintained up to 3-6 hours (still depends on admixture dosage, cement type, temper- ature)
  • Improved creep and shrinkage resistance characteristics
  • When used at higher dosages, SikaPlast®-178 KH can give extended working time

Packaging

200 L /1000 L

Product Details

Sustainability / Certifications / Approvals

APPROVALS / CERTIFICATES

SikaPlast®-178 KH meets the requirements of ASTM C 494 Type D & G.
SikaPlast®-178 KH conforms to type G when used at 0.8 - 1.0% dosage, depending on cement type used.
Product Information

Composition

Modified Poly carboxylate in water

Shelf life

12 months if stored properly in original unopened packaging

Storage conditions

Stored in dry conditions, protected from direct sunlight and at temperat- ures between +5 °C and +30 °C

Density

1.095 – 1.115 kg/L (At 20°C)

pH-Value

4.50 – 6.50 (At 25°C)
Technical Information

Concreting Guidance

Concrete placing: With the use of SikaPlast®-178 KH, concrete of highest quality is being produced, however state of the art concrete technology, such as mixing, placing vibrating and curing must be respected and applied.

Curing: Effective measures for concrete curing must be followed.

Specific Advice

SikaPlast®-178 KH is added to the gauging water prior to its addition to the dry mix or added separately to the wetted concrete mix.
For optimum utilization of the ultra-high range water reducer we recommend a minimum wet mixing time of 60 seconds.
When adding the balance of the batching water to adjust concrete consistency this should be done after a minimum of 2/3 of the wet mixing time to avoid surplus water in the concrete.

Application

Application Information

Compatibility

SikaPlast®-178 KH may be combined with all Sikament, Sika® Aer, Sika®Pump, Sikacrete® PP-1 products, but must be added separately to the mix and not pre-mixed prior its addition. SikaPlast®-178 KH is compatible with all Portland Cement types.
Consumption

Recommended Dosage

0.5 - 2 L per 100 kg of cement/binder
Typical dosage: 0.8 to 1.2 L per 100 kg of cement/binder

Documents